![]() ![]() :Interlock operation is not performed even if terminal alarm 1 is detected.ġ~256:When the preset position registered in advance is selected, the watch moves to the preset position when terminal alarm 1 is detected. This can be set when of the alarm is set to. Select the action to be interlocked when terminal alarm 1 is detected from the following. For example, if you set up an e-mail notification to a mobile terminal or a tablet terminal using an alarm, this setting prevents you from sending too much e-mail. Sets the time when the alarm is detected and the detection operation is not executed. :Disables all disturbance detection conditions. To set up the undesired detection area, use the tab on the alarm page. :If the disturbance detection area is not set, the entire area is set. :Disables all operation detection status. To set the operation detection area, use the tab on the alarm page. On:If the motion detection area is not set, the entire area is set. ・ :When the terminal status changes to, the automatic time adjustment is performed. Selecting Auto Time Adjustment displays the pull-down menu for short circuit and release selection. ![]() In the case of returning the time less than 5 seconds during SD recording, the time is not changed. When the signal is input, set to 00 minutes 00 seconds if the time difference from the normal time (00 minutes per hour) is 29 minutes or less. ・ :Time setting by terminal input is accepted. (When the input is, the input is switched to black and white) ・ :Receives black-and-white selector input. When the terminal status is, the alarm is detected periodically at intervals of no alarm detection time. ・ :When the terminal status changes to, an alarm is detected. → Schedule: Set SD recording (Movie recording setting screen) ![]() → Alarm: Setting details of image transfer or recording conditions Set the operating conditions selected in the event type setting. Terminal/operation/disturbance/sound detection ![]() → Schedule: Setting FTP/SFTP Periodic Transmission (FTP/SFTP Periodic Transmission Setting Screen) → Alarm: Sets terminal and operation detection (alarm setting screen) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |